You are currently not logged in! Enter your authentication credentials below to log in. You need to have cookies enabled to log in.
This shows you the differences between two versions of the page.
Next revision Both sides next revision | |||
en:processing:выделение_протяженных_объектов [2012/07/03 15:37] Александр Филонов created |
en:processing:выделение_протяженных_объектов [2012/07/03 17:55] Александр Филонов Перевел |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Lengthy object selection ====== | ====== Lengthy object selection ====== | ||
- | Режим выделения протяжённых объектов включается кнопкой в панели инструментов, расположенной в левой части изображения. Для этого нужно нажать и удерживать кнопку режима "Кривая" (а) - появится выпадающая панель инструментов, в которой можно выбрать режим "Выделение протяжённого объекта" (б): | + | Lengthy object selection mode can be turned on by the appropriate toolbar button, located on the left side of the image window. You should press and hold the "Curve" button (a), until the dropdown panel appears, with the "Lengthy object selection" button (b): |
- | {{:processing:mode_curve.jpg|Switching to the "Curve" mode}}(а){{:processing:mode_lengthy_object.jpg|Switching to the "Lengthy object selection" mode}}(б) | + | {{curvesel.png|Switching to the "Curve" mode}}(a){{lengthysel.png|Switching to the "Lengthy object selection" mode}}(b) |
- | Если в объекте найден только один скелет, то он сразу будет выбран и отмечен. В противном случае, если есть разветвления, черной линией будет отмечен скелет объекта, вдоль которого можно выбрать правильный контур: | + | Press the left mouse button in the beginning of the object - the black line will mark the skeleton of the object. Move the cursor to the end of the proper curve path, and the path between this point will be automatically selected: |
{{:processing:lengthy_object_sel1.jpg|Complicated object selection}} | {{:processing:lengthy_object_sel1.jpg|Complicated object selection}} | ||
- | Выделение можно делать в несколько этапов, нажимая клавишу "Ctrl" - тогда кривая будет достраиваться новым выбором. Если "Ctrl"не нажимать, то будет строиться новая кривая. Наводя мышь на точку кривой, можно удалить отдельную точку, с клавишей "Shift" можно перемещать точки кривой. Если на отрезке кривой нет точки, то ее можно добавить. Если удалять точку кривой с нажатой клавишей "Ctrl", будет удалена часть кривой от этой точки и до конца. | + | Object selection can be performed in several steps, using the "Ctrl" button. When "Ctrl" is held down, the current curve will be continued by the new one from the las point. If "Ctrl" is not pressed, the new curve will be built. Pointing the mouse to the intermidiate points, the point under cursor can be deleted or moved (with "Shift" button down). If there is no knot points under the cursor, the point will be added. If you point to the intermediate point and click it while"Ctrl" button is down, the rest of the curve will be deleted. |
- | {{:processing:lengthy_object_sel2.jpg|Complicated object selection finished}} | + | {{lengthysel.png|Complicated object selection finished}} |